To be able to run the ping from a firewall, you need to connect to the firewalls' CLI. The ping command only works from the local firewall device, as panorama does not have dataplane interfaces, so you can't add the source from panorama either. Please check the physical interface configuration to ensure that the "untagged subinterface" checkbox is NOT checked. In the event that you receive an error " bind: Cannot assign requested address" on firewall when sourcing ping from any interface other than the management interface, then the cause may be as simple as a checkbox. This is especially nice, as you have the ability to change what your source IP address is. You can use this command to help troubleshoot latency and connectivity issues from the management interface to hosts internal or external to your firewall. Ping command using the Management interfaceįrom the DP, you can use the following command to use an interface that owns ip y.y.y.y on the firewall to source the Ping command from: You have the ability to use the Ping command from both depending on how you use the Ping command.įrom the MP, you can use the following command to ping a single IP address using the Management Interface IP: ![]() ![]() This weeks Tips & Tricks is going to be talking about pinging in the firewall CLI, as there can sometimes be confusion and/or issues that arise when trying to ping from the CLI on the Palo Alto Networks firewall.ĭue to the nature of the Palo Alto Networks firewalls, you have two "planes" of existence: the Management Plane (MP) and the Data Plane (DP).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |